Bienvenido(a) a Palmadores.net Friday, November 17 2017 @ 08:08 PM CET


 Índice del foro > Técnica > Maquinaria y rigging New Topic Post Reply
 moving machinary over rough surfaces?
   
JensenBreck
 Thursday, November 09 2017 @ 01:30 PM CET (Leído 67 veces)  
+----
Carga / Descarga

Estado: desconectado


Identificado: 11/01/17
Mensajes: 2
Hello,

Im about to try and move a lathe about 7716lb. I have moved a small machining center probably half this weight before on pipe but it was dropped off onto a concrete slab.

The lathe will probably have to be unloaded onto the ground due to the transport configuration.

I went through old posts and saw some impressive use of UHMW but that would cost me a fortune to sorce.

would 2" pipe roll over a compacted gravel drive way?

I have considered putting formply down and using rollers or skates on that. what are peoples views on the likely hood of that working? I'm thinking it will deform and dimple and not roll. I could use use 1/2" flat bar as slides but youtube indicates this doesn't slide without a winch and slowly at best.
any sugestions so I don't have to have every combo on hand to test?


I didn't find the right solution from the internet.
References:

http://www.practicalmachinist.com/vb/material-handling-and-rigging/moving-machinary-over-rough-surfaces-337368/

explainer video

 
Profile Email
 Quote
Contenido generado en: 0.02 segundos
New Topic Post Reply

Tópico normal Tópico normal
Tópico Pegado Tópico Pegado
Tópico bloqueado Tópico bloqueado
Mensaje Nuevo Mensaje Nuevo
Tópico pegado con nuevo mensaje Tópico pegado con nuevo mensaje
Tópico bloqueado con nuevo mensaje Tópico bloqueado con nuevo mensaje
Ver mensajes anónimos 
Los usuarios anónimos pueden enviar 
Se permite todo HTML 
Contenido censurado